返回清單 發表

X360KEY Firmware(韌體.固件) v 2.1 更新, 多國語言版

本文章最後由 祥龍羅漢 於 2013-10-1 01:31 PM 編輯

xk3y firmware UPDATE v2.01-1
------------------------------------

下載:
Direct link -  http://xkeydownloads.com/firmware/02.01-1.zip
Mirror - http://www.sendspace.com/file/r8olk9



------------------------------------
xk3y firmware UPDATE v2.01-1
------------------------------------

1. Extract the three files "rootfs", "uImage" & "xkey.cfg"   
   解壓出三個檔 "rootfs", "uImage" & "xkey.cfg"   

2. Open xkey.cfg with Notepad and configure it if needed.
  打開 xkey.cfg 就你的需要開始編輯!
  變更語系: 將  #LANGUAGE=TCN        #Traditional Chinese  第一個#拿掉 , LANGUAGE=ENG 前加"#號 "
  1.    LANGUAGE=TCN        #Traditional Chinese
  2.    #LANGUAGE=ENG
複製代碼
2.1 Add the three files to the root folder of a Flash Drive or HDD. (Make sure to "eject" the drive properly from the PC, it may otherwise cause corrupt files)
        將三個檔案置於usb碟或硬碟的根目錄

3. Connect the Flash drive or HDD to your xk3y remote and wait for the xk3y to start the update.  
   usb碟連上x360key 進行更新!

3.1 The remote OLED will now display "UPDATING - PLEASE WAIT" for about 35 seconds. (Do not turn off your XB360 or disconnect the remote while updating)
    不要關閉XBOX , X360KEY 會顯示   "UPDATING - PLEASE WAIT"  約35秒 !

4. Once the update is completed, the OLED will display "UPDATE COMPLETE - RESET XBOX" Reboot your xbox and the xk3y should now be updated to the latest firmware.
  等到更新完成會顯示 "UPDATE COMPLETE - RESET XBOX"

5. That's it! Continue to enjoy using xk3y with the new features!

NOTE! If you use the same drive as you store games on to do the update with, then its recommended (not needed) to remove the "rootfs", "uImage" & "xkey.cfg" from the root of your drive after a firmware update. Since keeping them there will cause the xk3y to check the files if they are a newer firmware version then stored on your xk3y micro SD card, and because of that take longer time for your HDD to be recognized.
更新完成請記得將  "rootfs", "uImage" & "xkey.cfg" 從USB碟之中刪除...

-----------------------------------------
New features in 02.01-1 [15/7/13]
-----------------------------------------

        Added support for XK2     支援第二代 X360KEY  (XK2)
        Added support for USB DVD drives & burned/pressed games
        Added RTL8150 driver
        New Mr Waffles Code

回覆 1# 祥龍羅漢
2013年产的slim或者e可以用吗?
想买台新机来改x360key

TOP

回覆 2# hengshan505

新版的x360key 是有支援slim xbox 360 光碟機 Liteon 16d5s ( 1175 以後的機子...一般粗略判斷主機是2011/11 之後生產的)  ,是可以改x360key ,
只是工程浩大,跟改自製沒兩樣: 得先改脈衝板取得cpukey , 再換光碟機板, 再刷LTU2 韌體 !! (有興趣的人參看: https://www.youtube.com/watch?v=4UH-3VcP1h8)

這樣子的過程等於是(自製+軟改), 一般店家收費很高, 再者一般店家幾乎沒人要幹!
所以一般的回答,還是放棄改X360KEY , 如有需要就改自製即可吧 !  沒有經濟效益!

再者你目前買得到的機子都是 SLIM XBOX 360E 很難改機 ! 連自制都很不好搞了.. 呵呵

結論: 可以改,但是不好搞.工程浩大.很貴 !

TOP

回覆 1# 祥龍羅漢

版主大人
我没有黑色控制盒子
怎么更新固件啊?

TOP

返回清單